Help¶

Enable support for NPCX I2C driver. The NPCX SMB/I2C modules provides full support for a two-wire SMBus/I2C synchronous serial interface. Each interface is a two-wire serial interface that is compatible with both Intel SMBus and Philips I2C physical layer. There are 8 SMBus modules and 10 buses in NPCX7 series.

Help¶

This option enables the I2C driver for NPCX family of processors. Say y if you wish to use I2C modules on NPCX MCU.

Direct dependencies¶

(I2C && SOC_SERIES_NPCX7) || (SOC_FAMILY_NPCX && I2C)

(Includes any dependencies from ifs and menus.)

Default¶

y

Kconfig definitions¶

At soc/arm/nuvoton_npcx/npcx7/Kconfig.defconfig.series:76

Included via Kconfig:8 → Kconfig.zephyr:19 → /home/runner/work/bridle/bridle/workspace/build/Kconfig/Kconfig.soc.defconfig:1 → soc/arm/nuvoton_npcx/Kconfig.defconfig:6

Menu path: (Top)

config I2C_NPCX
    bool
    default y
    depends on I2C && SOC_SERIES_NPCX7
    help
      Enable support for NPCX I2C driver. The NPCX SMB/I2C modules provides
      full support for a two-wire SMBus/I2C synchronous serial interface.
      Each interface is a two-wire serial interface that is compatible with
      both Intel SMBus and Philips I2C physical layer. There are 8 SMBus
      modules and 10 buses in NPCX7 series.

At drivers/i2c/Kconfig.npcx:6

Included via Kconfig:8 → Kconfig.zephyr:32 → drivers/Kconfig:40 → drivers/i2c/Kconfig:42

Menu path: (Top) → Device Drivers → I2C Drivers

config I2C_NPCX
    bool "Nuvoton NPCX embedded controller (EC) I2C driver"
    depends on SOC_FAMILY_NPCX && I2C
    help
      This option enables the I2C driver for NPCX family of
      processors.
      Say y if you wish to use I2C modules on NPCX MCU.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)