Help¶

Say Y if your board uses USB DISCONNECT pin to enable the pull-up resistor on USB DP.

Direct dependencies¶

USB_DC_STM32 && USB

(Includes any dependencies from ifs and menus.)

Defaults¶

No defaults. Implicitly defaults to n.

Symbols that select this symbol¶

BOARD_OLIMEXINO_STM32

Kconfig definition¶

At drivers/usb/device/Kconfig:96

Included via Kconfig:8 → Kconfig.zephyr:32 → drivers/Kconfig:68 → drivers/usb/Kconfig:11

Menu path: (Top) → Device Drivers → USB

config USB_DC_STM32_DISCONN_ENABLE
    bool
    depends on USB_DC_STM32 && USB
    help
      Say Y if your board uses USB DISCONNECT pin to enable the
      pull-up resistor on USB DP.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)