:orphan:

.. title:: SPI_0_OP_MODES

.. option:: CONFIG_SPI_0_OP_MODES

*Port 0 supported operation modes (master/slave/both)*

Type: ``int``

Help
====

This sets the supported operation modes at runtime, by the SPI
port 0, where:
1 is MASTER mode only (default)
2 is SLAVE mode only
3 is both modes are available.

Direct dependencies
===================

(\ :option:`SPI_XEC_QMSPI <CONFIG_SPI_XEC_QMSPI>` && \ :option:`SPI <CONFIG_SPI>` && \ :option:`BOARD_MEC15XXEVB_ASSY6853 <CONFIG_BOARD_MEC15XXEVB_ASSY6853>`) || (\ :option:`SPI_0 <CONFIG_SPI_0>` && \ :option:`SPI <CONFIG_SPI>`)

*(Includes any dependencies from ifs and menus.)*

Defaults
========

- 1
- 1

Kconfig definitions
===================

.. highlight:: kconfig

At ``boards/arm/mec15xxevb_assy6853/Kconfig.defconfig:62``

Included via ``Kconfig:8`` → ``Kconfig.zephyr:18``

Menu path: (Top)

.. parsed-literal::

    config SPI_0_OP_MODES
    	int
    	default 1
    	depends on \ :option:`SPI_XEC_QMSPI <CONFIG_SPI_XEC_QMSPI>` && \ :option:`SPI <CONFIG_SPI>` && \ :option:`BOARD_MEC15XXEVB_ASSY6853 <CONFIG_BOARD_MEC15XXEVB_ASSY6853>`

----

At ``drivers/spi/Kconfig:44``

Included via ``Kconfig:8`` → ``Kconfig.zephyr:32`` → ``drivers/Kconfig:38``

Menu path: (Top) → Device Drivers → SPI hardware bus support → SPI port 0

.. parsed-literal::

    config SPI_0_OP_MODES
    	int "Port 0 supported operation modes (master/slave/both)"
    	range 1 3
    	default 1
    	depends on \ :option:`SPI_0 <CONFIG_SPI_0>` && \ :option:`SPI <CONFIG_SPI>`
    	help
    	  This sets the supported operation modes at runtime, by the SPI
    	  port 0, where:
    	  1 is MASTER mode only (default)
    	  2 is SLAVE mode only
    	  3 is both modes are available.

*(The 'depends on' condition includes propagated dependencies from ifs and menus.)*