:orphan:

.. title:: BT_RPMSG_NRF53

.. option:: CONFIG_BT_RPMSG_NRF53

*nRF53 configuration of RPMsg*

Type: ``bool``

Help
====

.. code-block:: none

    Enable RPMsg configuration for nRF53. Two channels of the IPM driver
    are used in the HCI driver: channel 0 for TX and channel 1 for RX.

Direct dependencies
===================

\ :option:`BT_RPMSG <CONFIG_BT_RPMSG>` && \ :option:`BT_HCI <CONFIG_BT_HCI>` && \ :option:`BT <CONFIG_BT>` && !\ :option:`BT_CTLR <CONFIG_BT_CTLR>`

*(Includes any dependencies from ifs and menus.)*

Default
=======

- y if \ :option:`SOC_NRF5340_CPUAPP <CONFIG_SOC_NRF5340_CPUAPP>`

Symbols selected by this symbol
===============================

- \ :option:`RPMSG_SERVICE <CONFIG_RPMSG_SERVICE>`

Kconfig definition
==================



At ``<Zephyr Driver>/bluetooth/hci/Kconfig:116``

Included via ``Kconfig:8`` → ``Kconfig.zephyr:32`` → ``<Zephyr Driver>/Kconfig:8`` → ``<Zephyr Driver>/bluetooth/Kconfig:16``

Menu path: (Top) → Device Drivers → Bluetooth Drivers

.. code-block:: kconfig

    config BT_RPMSG_NRF53
    	bool "nRF53 configuration of RPMsg"
    	default y if SOC_NRF5340_CPUAPP
    	select RPMSG_SERVICE
    	depends on BT_RPMSG && BT_HCI && BT && !BT_CTLR
    	help
    	  Enable RPMsg configuration for nRF53. Two channels of the IPM driver
    	  are used in the HCI driver: channel 0 for TX and channel 1 for RX.

*(The 'depends on' condition includes propagated dependencies from ifs and menus.)*