:orphan:

.. title:: SOC_MEC1501_VCI_PINS_AS_GPIOS

.. option:: CONFIG_SOC_MEC1501_VCI_PINS_AS_GPIOS

*Use VCI block pins as GPIOS*

Type: ``bool``

Help
====

.. code-block:: none

    By default these pins are not GPIOs, but HW controlled.
    Set this if VCI pin block HW logic is not required in the board
    design.

Direct dependencies
===================

\ :option:`SOC_FAMILY_MEC <CONFIG_SOC_FAMILY_MEC>`

*(Includes any dependencies from ifs and menus.)*

Default
=======

- y

Kconfig definition
==================



At ``<Zephyr SoC>/arm/microchip_mec/mec1501/Kconfig.soc:72``

Included via ``Kconfig:8`` → ``Kconfig.zephyr:28`` → ``<Zephyr SoC>/Kconfig:11`` → ``<BuildDir>/kconfig/Kconfig.soc.arch:2`` → ``<Zephyr SoC>/arm/microchip_mec/Kconfig:15``

Menu path: (Top) → Hardware Configuration

.. code-block:: kconfig

    config SOC_MEC1501_VCI_PINS_AS_GPIOS
    	bool "Use VCI block pins as GPIOS"
    	default y
    	depends on SOC_FAMILY_MEC
    	help
    	  By default these pins are not GPIOs, but HW controlled.
    	  Set this if VCI pin block HW logic is not required in the board
    	  design.

*(The 'depends on' condition includes propagated dependencies from ifs and menus.)*