:orphan:

.. title:: SPI_2_NRF_SPIM

.. option:: CONFIG_SPI_2_NRF_SPIM

*(No prompt -- not directly user assignable.)*

Type: ``bool``

Help
====

.. code-block:: none

    Enable nRF SPI Master with EasyDMA on port 2.

Direct dependencies
===================

(\ :option:`SPI <CONFIG_SPI>` && \ :option:`BOARD_ARDUINO_NANO_33_BLE <CONFIG_BOARD_ARDUINO_NANO_33_BLE>`) || ((!\ :option:`SOC_NRF52832 <CONFIG_SOC_NRF52832>` || \ :option:`SOC_NRF52832_ALLOW_SPIM_DESPITE_PAN_58 <CONFIG_SOC_NRF52832_ALLOW_SPIM_DESPITE_PAN_58>`) && \ :option:`SPI_NRFX <CONFIG_SPI_NRFX>` && \ :option:`SPI <CONFIG_SPI>`)

*(Includes any dependencies from ifs and menus.)*

Defaults
========

- y
- n

Symbols selected by this symbol
===============================

- \ :option:`NRFX_SPIM2 <CONFIG_NRFX_SPIM2>`

Kconfig definitions
===================



At ``<Zephyr Boards>/arm/arduino_nano_33_ble/Kconfig.defconfig:36``

Included via ``Kconfig:8`` → ``Kconfig.zephyr:18``

Menu path: (Top)

.. code-block:: kconfig

    config SPI_2_NRF_SPIM
    	bool
    	default y
    	depends on SPI && BOARD_ARDUINO_NANO_33_BLE

----

At ``<Zephyr Driver>/spi/Kconfig.nrfx:105``

Included via ``Kconfig:8`` → ``Kconfig.zephyr:32`` → ``<Zephyr Driver>/Kconfig:38`` → ``<Zephyr Driver>/spi/Kconfig:58``

Menu path: (Top) → Device Drivers → SPI hardware bus support → nRF SPI nrfx drivers

.. code-block:: kconfig

    config SPI_2_NRF_SPIM
    	bool
    	default n
    	select NRFX_SPIM2
    	depends on (!SOC_NRF52832 || SOC_NRF52832_ALLOW_SPIM_DESPITE_PAN_58) && SPI_NRFX && SPI
    	help
    	  Enable nRF SPI Master with EasyDMA on port 2.

*(The 'depends on' condition includes propagated dependencies from ifs and menus.)*