:orphan:

.. title:: USB_DC_STM32_DISCONN_ENABLE

.. option:: CONFIG_USB_DC_STM32_DISCONN_ENABLE

*(No prompt -- not directly user assignable.)*

Type: ``bool``

Help
====

.. code-block:: none

    Say Y if your board uses USB DISCONNECT pin to enable the
    pull-up resistor on USB DP.

Direct dependencies
===================

\ :option:`USB_DC_STM32 <CONFIG_USB_DC_STM32>` && \ :option:`USB <CONFIG_USB>`

*(Includes any dependencies from ifs and menus.)*

Defaults
========

No defaults. Implicitly defaults to ``n``.

Symbols that select this symbol
===============================

- \ :option:`BOARD_OLIMEXINO_STM32 <CONFIG_BOARD_OLIMEXINO_STM32>`

Kconfig definition
==================



At ``<Zephyr Driver>/usb/device/Kconfig:105``

Included via ``Kconfig:8`` → ``Kconfig.zephyr:32`` → ``<Zephyr Driver>/Kconfig:68`` → ``<Zephyr Driver>/usb/Kconfig:11``

Menu path: (Top) → Device Drivers → USB

.. code-block:: kconfig

    config USB_DC_STM32_DISCONN_ENABLE
    	bool
    	depends on USB_DC_STM32 && USB
    	help
    	  Say Y if your board uses USB DISCONNECT pin to enable the
    	  pull-up resistor on USB DP.

*(The 'depends on' condition includes propagated dependencies from ifs and menus.)*