:orphan: .. title:: CONFIG_CLOCK_STM32_PLL_PREDIV .. kconfig:: CONFIG_CLOCK_STM32_PLL_PREDIV CONFIG_CLOCK_STM32_PLL_PREDIV ############################# *PREDIV Prescaler* Type: ``int`` Help ==== .. code-block:: none PREDIV is a PLL clock signal prescaler for the HSE output. It is supported by those parts that do not support PREDIV1. If configured on a non-supported part, this config will be ignored. Allowed values: 1 - 16. Direct dependencies =================== \ :kconfig:`CLOCK_STM32_SYSCLK_SRC_PLL ` && (\ :kconfig:`SOC_SERIES_STM32F0X ` || \ :kconfig:`SOC_SERIES_STM32F3X `) && !\ :kconfig:`CLOCK_CONTROL_STM32_HAS_DTS ` && !\ :kconfig:`SOC_SERIES_STM32MP1X ` && \ :kconfig:`CLOCK_CONTROL_STM32_CUBE ` && \ :kconfig:`CLOCK_CONTROL ` *(Includes any dependencies from ifs and menus.)* Default ======= - 1 Kconfig definition ================== At ``/clock_control/Kconfig.stm32f0_f3:8`` Included via ``Kconfig:8`` → ``Kconfig.zephyr:42`` → ``/Kconfig:56`` → ``/clock_control/Kconfig:25`` → ``/clock_control/Kconfig.stm32:150`` Menu path: (Top) → Device Drivers → Hardware clock controller support → STM32 Reset & Clock Control .. code-block:: kconfig config CLOCK_STM32_PLL_PREDIV int "PREDIV Prescaler" range 1 16 default 1 depends on CLOCK_STM32_SYSCLK_SRC_PLL && (SOC_SERIES_STM32F0X || SOC_SERIES_STM32F3X) && !CLOCK_CONTROL_STM32_HAS_DTS && !SOC_SERIES_STM32MP1X && CLOCK_CONTROL_STM32_CUBE && CLOCK_CONTROL help PREDIV is a PLL clock signal prescaler for the HSE output. It is supported by those parts that do not support PREDIV1. If configured on a non-supported part, this config will be ignored. Allowed values: 1 - 16. *(The 'depends on' condition includes propagated dependencies from ifs and menus.)*