:orphan: .. title:: CONFIG_SOC_MEC1501_DEBUG_AND_ETM_TRACING .. kconfig:: CONFIG_SOC_MEC1501_DEBUG_AND_ETM_TRACING CONFIG_SOC_MEC1501_DEBUG_AND_ETM_TRACING ######################################## *Debug support via Serial wire debug* *Debug support via Serial wire debug* Type: ``bool`` Help ==== .. code-block:: none JTAG port in SWD mode and SWV as tracing method. UART2 can be used, but ADC00-03 cannot. Help ==== .. code-block:: none JTAG port in SWD mode and SWV as tracing method. UART2 can be used, but ADC00-03 cannot. Direct dependencies =================== \ :ref:` ` || \ :ref:` ` *(Includes any dependencies from ifs and menus.)* Kconfig definitions =================== At ``/arm/microchip_mec/mec1501/Kconfig.soc:114`` Included via ``Kconfig:8`` → ``Kconfig.zephyr:38`` → ``/Kconfig:15`` → ``/kconfig/Kconfig.soc.arch:2`` → ``/arm/microchip_mec/Kconfig:15`` Menu path: (Top) → Hardware Configuration → MEC1501 debug interface trace configuration .. code-block:: kconfig config SOC_MEC1501_DEBUG_AND_ETM_TRACING bool "Debug support via Serial wire debug" depends on help JTAG port in SWD mode and SWV as tracing method. UART2 can be used, but ADC00-03 cannot. ---- At ``/arm/microchip_mec/mec1501/Kconfig.soc:114`` Included via ``Kconfig:8`` → ``Kconfig.zephyr:38`` → ``/Kconfig:18`` → ``/arm/microchip_mec/Kconfig:15`` Menu path: (Top) → Hardware Configuration → MEC1501 debug interface trace configuration .. code-block:: kconfig config SOC_MEC1501_DEBUG_AND_ETM_TRACING bool "Debug support via Serial wire debug" depends on help JTAG port in SWD mode and SWV as tracing method. UART2 can be used, but ADC00-03 cannot. *(The 'depends on' condition includes propagated dependencies from ifs and menus.)*