:orphan:

.. title:: CONFIG_SPI_4_NRF_RX_DELAY

.. kconfig:: CONFIG_SPI_4_NRF_RX_DELAY

CONFIG_SPI_4_NRF_RX_DELAY
#########################

*SPIM4 MISO sampling delay*

Type: ``int``

Help
====

.. code-block:: none

    Number of 64 MHz clock cycles (15.625 ns) delay from the sampling
    edge of SCK (leading or trailing, depending on the CPHA setting used)
    until the input serial data on MISO is actually sampled.

Direct dependencies
===================

\ :kconfig:`SPI_4_NRF_SPIM <CONFIG_SPI_4_NRF_SPIM>` && \ :kconfig:`SOC_NRF5340_CPUAPP <CONFIG_SOC_NRF5340_CPUAPP>` && \ :kconfig:`SPI_NRFX <CONFIG_SPI_NRFX>` && \ :kconfig:`SPI <CONFIG_SPI>`

*(Includes any dependencies from ifs and menus.)*

Default
=======

- 2

Kconfig definition
==================



At ``<Zephyr Driver>/spi/Kconfig.nrfx:182``

Included via ``Kconfig:8`` → ``Kconfig.zephyr:42`` → ``<Zephyr Driver>/Kconfig:40`` → ``<Zephyr Driver>/spi/Kconfig:66``

Menu path: (Top) → Device Drivers → SPI hardware bus support → nRF SPI nrfx drivers

.. code-block:: kconfig

    config SPI_4_NRF_RX_DELAY
    	int "SPIM4 MISO sampling delay"
    	range 0 7
    	default 2
    	depends on SPI_4_NRF_SPIM && SOC_NRF5340_CPUAPP && SPI_NRFX && SPI
    	help
    	  Number of 64 MHz clock cycles (15.625 ns) delay from the sampling
    	  edge of SCK (leading or trailing, depending on the CPHA setting used)
    	  until the input serial data on MISO is actually sampled.

*(The 'depends on' condition includes propagated dependencies from ifs and menus.)*