:orphan:

.. title:: CONFIG_USB_DC_STM32_DISCONN_ENABLE

.. kconfig:: CONFIG_USB_DC_STM32_DISCONN_ENABLE

CONFIG_USB_DC_STM32_DISCONN_ENABLE
##################################

*(No prompt -- not directly user assignable.)*

Type: ``bool``

Help
====

.. code-block:: none

    Say Y if your board uses USB DISCONNECT pin to enable the
    pull-up resistor on USB DP.

Direct dependencies
===================

\ :kconfig:`USB_DC_STM32 <CONFIG_USB_DC_STM32>` && \ :kconfig:`USB_DEVICE_DRIVER <CONFIG_USB_DEVICE_DRIVER>`

*(Includes any dependencies from ifs and menus.)*

Defaults
========

No defaults. Implicitly defaults to ``n``.

Symbols that select this symbol
===============================

- \ :kconfig:`BOARD_OLIMEXINO_STM32 <CONFIG_BOARD_OLIMEXINO_STM32>`

Kconfig definition
==================



At ``<Zephyr Driver>/usb/device/Kconfig:34``

Included via ``Kconfig:8`` → ``Kconfig.zephyr:42`` → ``<Zephyr Driver>/Kconfig:70`` → ``<Zephyr Driver>/usb/Kconfig:6``

Menu path: (Top) → Device Drivers → Enable USB device controller drivers → USB device controller driver for STM32 devices

.. code-block:: kconfig

    config USB_DC_STM32_DISCONN_ENABLE
    	bool
    	depends on USB_DC_STM32 && USB_DEVICE_DRIVER
    	help
    	  Say Y if your board uses USB DISCONNECT pin to enable the
    	  pull-up resistor on USB DP.

*(The 'depends on' condition includes propagated dependencies from ifs and menus.)*