:orphan:

.. title:: choice: Temperature measurement mode

.. _choice_375:

.. describe:: choice: Temperature measurement mode

*Temperature measurement mode*

Type: ``bool``

Help
====

.. code-block:: none

    Enable/disable temperature measurements and set measurement mode.

Direct dependencies
===================

\ :kconfig:`ENS210 <CONFIG_ENS210>` && \ :kconfig:`SENSOR <CONFIG_SENSOR>`

*(Includes any dependencies from ifs and menus.)*

Default
=======

- \ :kconfig:`ENS210_TEMPERATURE_CONTINUOUS <CONFIG_ENS210_TEMPERATURE_CONTINUOUS>`

Choice options
==============

- \ :kconfig:`ENS210_TEMPERATURE_OFF <CONFIG_ENS210_TEMPERATURE_OFF>`
- \ :kconfig:`ENS210_TEMPERATURE_SINGLE <CONFIG_ENS210_TEMPERATURE_SINGLE>`
- \ :kconfig:`ENS210_TEMPERATURE_CONTINUOUS <CONFIG_ENS210_TEMPERATURE_CONTINUOUS>`

Kconfig definition
==================



At ``<Zephyr Driver>/sensor/ens210/Kconfig:13``

Included via ``Kconfig:8`` → ``Kconfig.zephyr:42`` → ``<Zephyr Driver>/Kconfig:64`` → ``<Zephyr Driver>/sensor/Kconfig:83``

Menu path: (Top) → Device Drivers → Sensor Drivers → ENS210 Digital Temperature and Humidity sensor

.. code-block:: kconfig

    choice
    	bool "Temperature measurement mode"
    	default ENS210_TEMPERATURE_CONTINUOUS
    	depends on ENS210 && SENSOR
    	help
    	  Enable/disable temperature measurements and set measurement mode.

*(The 'depends on' condition includes propagated dependencies from ifs and menus.)*