:orphan:

.. title:: CONFIG_INA230_TRIGGER

.. kconfig:: CONFIG_INA230_TRIGGER

CONFIG_INA230_TRIGGER
#####################

*INA230 trigger mode*

Type: ``bool``

Help
====

.. code-block:: none

    Set to enable trigger mode using gpio interrupt, where
    interrupts are configured to line ALERT PIN.

Direct dependencies
===================

\ :kconfig:`INA230 <CONFIG_INA230>` && \ :kconfig:`INA23X <CONFIG_INA23X>` && \ :kconfig:`SENSOR <CONFIG_SENSOR>`

*(Includes any dependencies from ifs and menus.)*

Defaults
========

No defaults. Implicitly defaults to ``n``.

Kconfig definition
==================



At ``<Driver>/sensor/ina23x/Kconfig:23``

Included via ``Kconfig:8`` → ``Kconfig.zephyr:42`` → ``<Driver>/Kconfig:64`` → ``<Driver>/sensor/Kconfig:117``

Menu path: (Top) → Device Drivers → Sensor Drivers → INA23X Current and Power Monitor

.. code-block:: kconfig

    config INA230_TRIGGER
    	bool "INA230 trigger mode"
    	depends on INA230 && INA23X && SENSOR
    	help
    	  Set to enable trigger mode using gpio interrupt, where
    	  interrupts are configured to line ALERT PIN.

*(The 'depends on' condition includes propagated dependencies from ifs and menus.)*