:orphan:

.. title:: CONFIG_MPU9250_TRIGGER_OWN_THREAD

.. kconfig:: CONFIG_MPU9250_TRIGGER_OWN_THREAD

CONFIG_MPU9250_TRIGGER_OWN_THREAD
#################################

*Use own thread*

Type: ``bool``

Direct dependencies
===================

\ :kconfig:`GPIO <CONFIG_GPIO>` && \ :ref:`<choice: Trigger mode> <choice_331>`

*(Includes any dependencies from ifs and menus.)*

Symbols selected by this symbol
===============================

- \ :kconfig:`MPU9250_TRIGGER <CONFIG_MPU9250_TRIGGER>`

Kconfig definition
==================



At ``<Driver>/sensor/mpu9250/Kconfig:28``

Included via ``Kconfig:8`` → ``Kconfig.zephyr:42`` → ``<Driver>/Kconfig:64`` → ``<Driver>/sensor/Kconfig:177``

Menu path: (Top) → Device Drivers → Sensor Drivers → MPU9250 Nine-Axis Motion Tracking Device → Trigger mode

.. code-block:: kconfig

    config MPU9250_TRIGGER_OWN_THREAD
    	bool "Use own thread"
    	select MPU9250_TRIGGER
    	depends on GPIO && <choice>

*(The 'depends on' condition includes propagated dependencies from ifs and menus.)*