worldsemi,ws2812-rpi_pico-pio
Vendor: Worldsemi Co., Limited
Description
Worldsemi WS2812 LED strip driver based on RaspberryPi Pico's PIO
This driver not configure output pin.
Need to configure the pins with pinctrl in parent node.
Properties
Properties not inherited from the base binding file.
Name |
Type |
Details |
---|---|---|
|
|
Set the pin number to output.
This property is required. |
|
|
Specify the number of times a waveform representing 1 bit is
transmitted per second. It is same meaning as bit-per-seconds.
WS2812 works with 800000.
Set the value 400000 for WS2811, 2000000 for WS2813 and WS2815.
|
|
|
The number of devices in the daisy-chain.
This property is required. |
|
|
Channel to color mapping (or pixel order).
For example a GRB channel to color mapping would be
color-mapping = <LED_COLOR_ID_GREEN
LED_COLOR_ID_RED
LED_COLOR_ID_BLUE>;
This property is required. |
|
|
Minimum delay to wait (in microseconds) to make sure that the strip has
latched the signal. If omitted, a default value of 8 microseconds is used.
This default is good for the WS2812 controllers. Note that despite the
WS2812 datasheet states that a 50 microseconds delay is required, it seems
6 microseconds is enough. The default is set to 8 microseconds just to be
safe.
Default value: |
Deprecated properties not inherited from the base binding file.
(None)
Properties inherited from the base binding file, which defines common properties that may be set on many nodes. Not all of these may apply to the “worldsemi,ws2812-rpi_pico-pio” compatible.
(None)