Steppers
The stepper driver API provides a set of functions for controlling and configuring stepper drivers.
Configure Stepper Driver
Configure micro-stepping resolution using
stepper_set_micro_step_res()andstepper_get_micro_step_res().Configure reference position in microsteps using
stepper_set_reference_position()andstepper_get_actual_position().Set step interval in nanoseconds between steps using
stepper_set_microstep_interval()Enable the stepper driver using
stepper_enable().
Control Stepper
Move by +/- micro-steps also known as relative movement using
stepper_move_by().Move to a specific position also known as absolute movement using
stepper_move_to().Run continuously with a constant step interval in a specific direction until a stop is detected using
stepper_run().Check if the stepper is moving using
stepper_is_moving().Register an event callback using
stepper_set_event_callback().
Device Tree
In the context of stepper controllers device tree provides the initial hardware configuration for stepper drivers on a per device level. Each device must specify a device tree binding in Zephyr, and ideally, a set of hardware configuration options for things such as current settings, ramp parameters and furthermore. These can then be used in a boards devicetree to configure a stepper driver to its initial state.
See examples in:
Discord
Zephyr has a stepper discord channel for stepper related discussions, which is open to all.
API Reference
A common set of functions which should be implemented by all stepper drivers.