ST Nucleo F401RE

Overview

This is a set of Bridle’s extension to the original Zephyr upstream board Nucleo F401RE with some adaptions and improvement on Devicetree level.

List of extensions

  • add the missing Arduino UNO R3 specific interface labels:

    • arduino_serial: &usart2 {};

Note

On Nucleo F401RE pin D0 (RX) and D1 (TX) should be disconnected from the on-board STLinx/V2; open the solder bridges SB13 (RX) and SB14 (TX). For more details, see schematic MB1136-C05 on sheet 4 and manual UM1724 section 6.8 on page 25 and table 10 on page 27.