:orphan: .. raw:: html .. dtcompatible:: nxp,spc-bandgap-buffer .. _dtbinding_nxp_spc_bandgap_buffer: nxp,spc-bandgap-buffer ###################### .. sidebar:: Overview :Name: ``nxp,spc-bandgap-buffer`` :Vendor: :ref:`NXP Semiconductors N.V. ` :Used in: :zephyr:board-catalog:`List of boards <#compatibles=nxp,spc-bandgap-buffer>` using this compatible :Driver: :zephyr_file:`drivers/regulator/regulator_nxp_spc_bandgap.c` Description *********** .. code-block:: none NXP SPC buffered bandgap output Properties ********** .. tabs:: .. group-tab:: Node specific properties Properties not inherited from the base binding file. .. list-table:: :widths: 1 1 4 :header-rows: 1 * - Name - Type - Details * - ``regulator-always-on`` - ``boolean`` - .. code-block:: none boolean, regulator should never be disabled * - ``regulator-boot-on`` - ``boolean`` - .. code-block:: none bootloader/firmware enabled regulator. It's expected that this regulator was left on by the bootloader. If the bootloader didn't leave it on then OS should turn it on at boot but shouldn't prevent it from being turned off later. This property is intended to only be used for regulators where software cannot read the state of the regulator. .. group-tab:: Deprecated node specific properties Deprecated properties not inherited from the base binding file. (None) .. group-tab:: Base properties Properties inherited from the base binding file, which defines common properties that may be set on many nodes. Not all of these may apply to the "nxp,spc-bandgap-buffer" compatible. (None)