atmel,sam-tc

Vendor: Atmel Corporation

Description

Atmel SAM Timer Counter (TC) node

Properties

Properties not inherited from the base binding file.

Name

Type

Details

pinctrl-0

phandles

Pin configuration/s for the first state. Content is specific to the
selected pin controller driver implementation.

pinctrl-1

phandles

Pin configuration/s for the second state. See pinctrl-0.

pinctrl-2

phandles

Pin configuration/s for the third state. See pinctrl-0.

pinctrl-3

phandles

Pin configuration/s for the fourth state. See pinctrl-0.

pinctrl-4

phandles

Pin configuration/s for the fifth state. See pinctrl-0.

pinctrl-names

string-array

Names for the provided states. The number of names needs to match the
number of states.

channel

int

Timer / Counter channel to use, channel 0 is the default.
Valid range: 0 - 2

clk

int

Clock source selection as defined by TCCLKS bit-field of TC_CMR
register. Consult the datasheet for the details.

nodivclk

boolean

If set to true the `clk` property is ignored. Instead the TC module is
driven directly via MCLK. Only supported on sam4e, same70, same70b,
samv71, samv71b SoC series.

reg-cmr

int

Alternate value of the CMR (Channel Mode Register) register.
If specified this value will be written to the register during driver
instance initialization instead of the default. It can be used to
configure the timer / counter in the custom mode. Together with other
properties like channel-num, pinctrl-0 this allows e.g. to configure
the driver to count events generated on the TIOA, TIOB signal connected
to the external pin.

reg-rc

int

Register C compare/match value. RC can be used as compare/match unit
for an specific timer unit. Their use depends on how timer channel
is configured,see reg-cmr. It can be used as trigger for both input
capture or counter mode, or even as event source. The RC register
behavior is SoC dependent. For more information and use cases,
check SoC datasheet and application notes.