CONFIG_INA23X_TRIGGER¶

Trigger mode

Type: bool

Help¶

Set to enable trigger mode using gpio interrupt, where
interrupts are configured to line ALERT PIN.

Direct dependencies¶

INA23X && SENSOR

(Includes any dependencies from ifs and menus.)

Defaults¶

No defaults. Implicitly defaults to n.

Kconfig definition¶

At <Zephyr Driver>/sensor/ina23x/Kconfig:13

Included via Kconfig:8 → Kconfig.zephyr:42 → <Zephyr Driver>/Kconfig:64 → <Zephyr Driver>/sensor/Kconfig:115

Menu path: (Top) → Device Drivers → Sensor Drivers → INA23X Current and Power Monitor

config INA23X_TRIGGER
    bool "Trigger mode"
    depends on INA23X && SENSOR
    help
      Set to enable trigger mode using gpio interrupt, where
      interrupts are configured to line ALERT PIN.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)