CONFIG_SOC_MEC1501_DEBUG_AND_SWV_TRACING¶

debug support via Serial Wire Debug and Viewer

Type: bool

Help¶

JTAG port in SWD mode and SWV as tracing method.
UART2 cannot be used. ADC00-03 can be used.

Help¶

JTAG port in SWD mode and SWV as tracing method.
UART2 cannot be used. ADC00-03 can be used.

Direct dependencies¶

<choice: MEC1501 debug interface trace configuration> || <choice: MEC1501 debug interface trace configuration>

(Includes any dependencies from ifs and menus.)

Kconfig definitions¶

At <Zephyr SoC>/arm/microchip_mec/mec1501/Kconfig.soc:120

Included via Kconfig:8 → Kconfig.zephyr:38 → <Zephyr SoC>/Kconfig:15 → <BuildDir>/kconfig/Kconfig.soc.arch:2 → <Zephyr SoC>/arm/microchip_mec/Kconfig:15

Menu path: (Top) → Hardware Configuration → MEC1501 debug interface trace configuration

config SOC_MEC1501_DEBUG_AND_SWV_TRACING
    bool "debug support via Serial Wire Debug and Viewer"
    depends on <choice>
    help
      JTAG port in SWD mode and SWV as tracing method.
      UART2 cannot be used. ADC00-03 can be used.

At <Zephyr SoC>/arm/microchip_mec/mec1501/Kconfig.soc:120

Included via Kconfig:8 → Kconfig.zephyr:38 → <Zephyr SoC>/Kconfig:18 → <Zephyr SoC>/arm/microchip_mec/Kconfig:15

Menu path: (Top) → Hardware Configuration → MEC1501 debug interface trace configuration

config SOC_MEC1501_DEBUG_AND_SWV_TRACING
    bool "debug support via Serial Wire Debug and Viewer"
    depends on <choice>
    help
      JTAG port in SWD mode and SWV as tracing method.
      UART2 cannot be used. ADC00-03 can be used.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)