CONFIG_SPI_2_NRF_SPIM¶

(No prompt – not directly user assignable.)

Type: bool

Help¶

Enable nRF SPI Master with EasyDMA on port 2.

Direct dependencies¶

(SPI && BOARD_ARDUINO_NANO_33_BLE) || ((!SOC_NRF52832 || SOC_NRF52832_ALLOW_SPIM_DESPITE_PAN_58) && SPI_NRFX && SPI)

(Includes any dependencies from ifs and menus.)

Defaults¶

y
n

Symbols selected by this symbol¶

NRFX_SPIM2

Kconfig definitions¶

At <Zephyr Boards>/arm/arduino_nano_33_ble/Kconfig.defconfig:29

Included via Kconfig:8 → Kconfig.zephyr:22

Menu path: (Top)

config SPI_2_NRF_SPIM
    bool
    default y
    depends on SPI && BOARD_ARDUINO_NANO_33_BLE

At <Zephyr Driver>/spi/Kconfig.nrfx:105

Included via Kconfig:8 → Kconfig.zephyr:42 → <Zephyr Driver>/Kconfig:40 → <Zephyr Driver>/spi/Kconfig:66

Menu path: (Top) → Device Drivers → SPI hardware bus support → nRF SPI nrfx drivers

config SPI_2_NRF_SPIM
    bool
    default n
    select NRFX_SPIM2
    depends on (!SOC_NRF52832 || SOC_NRF52832_ALLOW_SPIM_DESPITE_PAN_58) && SPI_NRFX && SPI
    help
      Enable nRF SPI Master with EasyDMA on port 2.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)