| 
| int  | bt_mesh_dfu_cli_send (struct bt_mesh_dfu_cli *cli, const struct bt_mesh_blob_cli_inputs *inputs, const struct bt_mesh_blob_io *io, const struct bt_mesh_dfu_cli_xfer *xfer) | 
|   | Start distributing a DFU.  More...
  | 
|   | 
| int  | bt_mesh_dfu_cli_suspend (struct bt_mesh_dfu_cli *cli) | 
|   | Suspend a DFU transfer.  More...
  | 
|   | 
| int  | bt_mesh_dfu_cli_resume (struct bt_mesh_dfu_cli *cli) | 
|   | Resume the suspended transfer.  More...
  | 
|   | 
| int  | bt_mesh_dfu_cli_cancel (struct bt_mesh_dfu_cli *cli, struct bt_mesh_msg_ctx *ctx) | 
|   | Cancel a DFU transfer.  More...
  | 
|   | 
| int  | bt_mesh_dfu_cli_apply (struct bt_mesh_dfu_cli *cli) | 
|   | Apply the completed DFU transfer.  More...
  | 
|   | 
| int  | bt_mesh_dfu_cli_confirm (struct bt_mesh_dfu_cli *cli) | 
|   | Confirm that the active transfer has been applied on the Target nodes.  More...
  | 
|   | 
| uint8_t  | bt_mesh_dfu_cli_progress (struct bt_mesh_dfu_cli *cli) | 
|   | Get progress as a percentage of completion.  More...
  | 
|   | 
| bool  | bt_mesh_dfu_cli_is_busy (struct bt_mesh_dfu_cli *cli) | 
|   | Check whether a DFU transfer is in progress.  More...
  | 
|   | 
| int  | bt_mesh_dfu_cli_imgs_get (struct bt_mesh_dfu_cli *cli, struct bt_mesh_msg_ctx *ctx, bt_mesh_dfu_img_cb_t cb, void *cb_data, uint8_t max_count) | 
|   | Perform a DFU image list request.  More...
  | 
|   | 
| int  | bt_mesh_dfu_cli_metadata_check (struct bt_mesh_dfu_cli *cli, struct bt_mesh_msg_ctx *ctx, uint8_t img_idx, const struct bt_mesh_dfu_slot *slot, struct bt_mesh_dfu_metadata_status *rsp) | 
|   | Perform a metadata check for the given DFU image slot.  More...
  | 
|   | 
| int  | bt_mesh_dfu_cli_status_get (struct bt_mesh_dfu_cli *cli, struct bt_mesh_msg_ctx *ctx, struct bt_mesh_dfu_target_status *rsp) | 
|   | Get the status of a Target node.  More...
  | 
|   | 
| int32_t  | bt_mesh_dfu_cli_timeout_get (void) | 
|   | Get the current procedure timeout value.  More...
  | 
|   | 
| void  | bt_mesh_dfu_cli_timeout_set (int32_t timeout) | 
|   | Set the procedure timeout value.  More...
  | 
|   |