renesas-rz-gpio.h File Reference

Go to the source code of this file.

Macros
#define	RZ_GPIO_IOLH_SHIFT   8U
	RZ/A,G,V-specific GPIO Flags The pin driving ability flags are encoded in the 8 upper bits of gpio_dt_flags_t as follows:
#define	RZ_GPIO_IOLH_SET(iolh_val)   (iolh_val << RZ_GPIO_IOLH_SHIFT)
#define	RZ_GPIO_FILTER_SHIFT   10U
#define	RZ_GPIO_FILNUM_SHIFT   1U
#define	RZ_GPIO_FILCLKSEL_SHIFT   3U
#define	RZ_GPIO_FILTER_SET(fillonoff, filnum, filclksel)

Macro Definition Documentation

RZ_GPIO_FILCLKSEL_SHIFT

#define RZ_GPIO_FILCLKSEL_SHIFT   3U

RZ_GPIO_FILNUM_SHIFT

#define RZ_GPIO_FILNUM_SHIFT   1U

RZ_GPIO_FILTER_SET

#define RZ_GPIO_FILTER_SET	(		fillonoff,
			filnum,
			filclksel
	)

Value:

        (((fillonoff) | ((filnum) << RZ_GPIO_FILNUM_SHIFT) |                                       \
          ((filclksel) << RZ_GPIO_FILCLKSEL_SHIFT))                                                \
         << RZ_GPIO_FILTER_SHIFT)

RZ_GPIO_FILTER_SHIFT

#define RZ_GPIO_FILTER_SHIFT   10U

RZ_GPIO_IOLH_SET

#define RZ_GPIO_IOLH_SET

(

iolh_val

)

(iolh_val << RZ_GPIO_IOLH_SHIFT)

RZ_GPIO_IOLH_SHIFT

#define RZ_GPIO_IOLH_SHIFT   8U

RZ/A,G,V-specific GPIO Flags The pin driving ability flags are encoded in the 8 upper bits of gpio_dt_flags_t as follows:

• Bit 8..9: Pin driving ability value
• Bit 10: Digital Noise Filter ON/OFF
• Bit 11..12: Digital Noise Filter Number value
• Bit 13..14: Digital Noise Filter Clock Selection value example: gpio-consumer { out-gpios = <&port8 2 (GPIO_PULL_UP | RZ_GPIO_FILTER_SET(1, 3, 3))>; }; gpio-consumer { out-gpios = <&port8 2 (GPIO_PULL_UP | RZ_GPIO_IOLH_SET(2))>; };