Bluetooth: ST Interactive GUI

Expose ST BlueNRG Bluetooth network coprocessor over UART

Overview

Expose the Bluetooth network coprocessor via UART to a PC to be used with the ST BlueNRG GUI app. In this case, the main MCU becomes an intermediate level, and it passes the data between the host (PC) and controller.

Requirements

• A board based on BlueNRG BLE module such as ST Disco L475 IOT01 (B-L475E-IOT01A)

• BlueNRG GUI application installed on your PC

Default UART settings

It depends on the board default settings for zephyr,bt-c2h-uart DTS property. The UART default settings are:

• Baudrate: 115200 bps

• 8 bits, no parity, 1 stop bit

Building and Running

This sample can be found under samples/boards/stm32/bluetooth/interactive_gui in the Zephyr tree.