TMC6460 Voltage Mode

Overview

This sample performs the full TMC6460 hardware bring-up (clock FSM commit, ADC reset, gate-driver enable) and then drives a BLDC motor in open-loop voltage mode, performing the explicit initialization that an evaluation-board firmware would normally handle.

Requirements

A board with an available SPI (or UART) bus.
A TMC6460 evaluation board with a BLDC motor connected and a suitable motor power supply.
Two GPIOs wired to the TMC6460 DRV_EN and SLEEPN pins, exposed via the tmc6460-drv-en and tmc6460-sleepn devicetree aliases.

The motor’s pole-pair count is read from the pole-pairs devicetree property, so a different motor is supported by editing only the board overlay.

Building and Running

west build -b nucleo_f413zh samples/drivers/misc/tmc6460
west flash

Replace nucleo_f413zh with your target board. If your board does not already have an overlay under boards/, create one that places the tmc6460 node on the correct SPI bus and defines the tmc6460-drv-en and tmc6460-sleepn GPIO aliases.

UART transport

To build the UART variant, supply the UART devicetree overlay and the transport configuration overlay:

west build -b nucleo_f413zh samples/drivers/misc/tmc6460 \
  -- -DDTC_OVERLAY_FILE=uart.overlay -DEXTRA_CONF_FILE=overlay-uart.conf
west flash

Without these arguments the sample builds for SPI (the default). The uart.overlay places the tmc6460 node on the UART bus and overlay-uart.conf switches the driver transport from SPI to UART.

Warning

The motor turns during this sample. Ensure it is mechanically safe to spin before running.