MSPI controller device specific configuration. More...

#include <mspi.h>

Data Fields
uint8_t	ce_num
	Configure CE0 or CE1 or more.

uint32_t	freq
	Configure frequency.

enum mspi_io_mode	io_mode
	Configure I/O mode.

enum mspi_data_rate	data_rate
	Configure data rate.

enum mspi_cpp_mode	cpp
	Configure clock polarity and phase.

enum mspi_endian	endian
	Configure transfer endian.

enum mspi_ce_polarity	ce_polarity
	Configure chip enable polarity.

bool	dqs_enable
	Configure DQS mode.

uint16_t	rx_dummy
	Configure number of clock cycles between addr and data in RX direction.

uint16_t	tx_dummy
	Configure number of clock cycles between addr and data in TX direction.

uint32_t	read_cmd
	Configure read command

uint32_t	write_cmd
	Configure write command

uint8_t	cmd_length
	Configure command length

uint8_t	addr_length
	Configure address length

uint32_t	mem_boundary
	Configure memory boundary

uint32_t	time_to_break
	Configure the time to break up a transfer into 2.

Detailed Description

MSPI controller device specific configuration.

Field Documentation

◆ addr_length

uint8_t mspi_dev_cfg::addr_length

Configure address length

◆ ce_num

uint8_t mspi_dev_cfg::ce_num

Configure CE0 or CE1 or more.

◆ ce_polarity

enum mspi_ce_polarity mspi_dev_cfg::ce_polarity

Configure chip enable polarity.

◆ cmd_length

uint8_t mspi_dev_cfg::cmd_length

Configure command length

◆ cpp

enum mspi_cpp_mode mspi_dev_cfg::cpp

Configure clock polarity and phase.

◆ data_rate

enum mspi_data_rate mspi_dev_cfg::data_rate

Configure data rate.

◆ dqs_enable

bool mspi_dev_cfg::dqs_enable

Configure DQS mode.

◆ endian

enum mspi_endian mspi_dev_cfg::endian

Configure transfer endian.

◆ freq

uint32_t mspi_dev_cfg::freq

Configure frequency.

◆ io_mode

enum mspi_io_mode mspi_dev_cfg::io_mode

Configure I/O mode.

◆ mem_boundary

uint32_t mspi_dev_cfg::mem_boundary

Configure memory boundary

◆ read_cmd

uint32_t mspi_dev_cfg::read_cmd

Configure read command

◆ rx_dummy

uint16_t mspi_dev_cfg::rx_dummy

Configure number of clock cycles between addr and data in RX direction.

◆ time_to_break

uint32_t mspi_dev_cfg::time_to_break

Configure the time to break up a transfer into 2.

◆ tx_dummy

uint16_t mspi_dev_cfg::tx_dummy

Configure number of clock cycles between addr and data in TX direction.

◆ write_cmd

uint32_t mspi_dev_cfg::write_cmd

Configure write command

The documentation for this struct was generated from the following file:

include/zephyr/drivers/mspi.h

Data Fields